Strap width is the first specification buyers ask about, and the one most often chosen by guesswork. Too narrow and the joint fails; too wide and you pay for strength you never use. Here is a practical way to decide.

PET strapping on a bundle of timber planks

Why width matters

Joint strength scales with band cross-section. A wider belt spreads the load over a larger weld area and tolerates higher tension. That is why heavy rigid loads almost always use 16–19 mm, while cartons and light bundles are fine at 13 mm.

Width by load type

Load Typical width Notes
Cartons, light pallets 13 mm PP is usually sufficient
Timber, wooden crates 13–16 mm PET recommended
Steel coils, brick, stone 16–19 mm PET, high tension
Plastic pipe bundles 13–16 mm Depends on bundle diameter

When 13 mm is enough

If your load is light, stable and not likely to settle, 13 mm band at moderate tension is usually the most economical choice. It also handles tighter corners and smaller packages more easily.

When 19 mm is better

Use 19 mm for dense, heavy loads that keep their shape — steel, stone, dense timber. The wider weld resists the high tension (up to 3500 N) these loads need, and it is less likely to cut into edges under pressure.

Tool compatibility

AECSORIX AE01 and AE02 battery tools cover the full 13–19 mm range, so you do not need a different tool for each width. Tension is adjustable from 600 to 3500 N and the LCD lets operators set it repeatably.

High-tension PET strapping on steel channels

Frequently asked questions

Can I use 19 mm band in a 13 mm tool? No. Always match the band width to the tool’s supported range.

Does a wider band mean slower work? Not with a battery tool — the weld and cut cycle is essentially the same regardless of width.

How do I confirm the right width? Send us a photo of your load and band; we will recommend a width and tension and can send a joint sample.

{“@context”:”https://schema.org”,”@type”:”FAQPage”,”mainEntity”:[{“@type”:”Question”,”name”:”Can I use 19 mm band in a 13 mm tool?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”No. Always match the band width to the tool’s supported range.”}},{“@type”:”Question”,”name”:”Does a wider band mean slower work?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”Not with a battery tool – the weld and cut cycle is essentially the same regardless of width.”}},{“@type”:”Question”,”name”:”How do I confirm the right width?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”Send us a photo of your load and band; we will recommend a width and tension and can send a joint sample.”}}]}

Need a recommendation for your load? Contact AECSORIX with your strap width and load weight, or WhatsApp +86 13606818153. Samples ship in 3 days.

← Back to Blog

Leave a Reply

Your email address will not be published. Required fields are marked *