Most strap failures come from three causes — wrong tension, the wrong band for the load, or worn friction and cutter parts. Check these before assuming the tool is faulty. This guide covers six common faults on 13–19 mm battery strapping tools, with the symptom, likely cause and the fix for each.

Faults at a glance

Symptom Likely cause Fix
Weak joint Tension too low or worn friction wheel Raise tension; replace friction parts
Band breaks at the weld Tension too high or band mismatch Reduce tension; confirm band grade
Band will not feed Wrong band width or obstruction in the path Use 13–19 mm band; clear the path
Tension drops after strapping PP used on a load that settles Switch to PET for rigid loads
Cut fails or leaves a tail Worn cutter Replace cutter (stocked spare)
Battery will not charge Charger/plug or low cycle life Check plug and outlet; replace pack if aged

1. Weak joint

A joint that slips usually means tension is too low for the band width, or the friction wheel is worn. Raise tension in small steps and make a test joint. If the weld still looks weak, inspect the friction wheel. The tension-setting method is in how to adjust strapping tension.

2. Band breaks at the weld

The opposite problem: tension too high, or a band grade that cannot take the setting. Reduce tension and confirm the band is PET for heavy loads. See PET vs PP strapping.

3. Band will not feed

Confirm the band is within 13–19 mm and sits correctly in the threading path. Debris or a damaged band end will stop the feed. Both AE01 and AE02 use the same path.

4. Tension drops after strapping

PP relaxes over time. If the load settles (timber, brick, coils), switch to PET, which retains tension. Band choice by load is covered in how to choose a tool by load.

5. Cut fails or leaves a long tail

A worn cutter is the usual cause. Stocked wear spares include BB4003, BB2006, BB6004, BB6003 and OUT405. Replace on schedule rather than waiting for total failure.

6. Battery will not charge

Check the charger plug for your country and the outlet first. The charger accepts 100–245 VAC. A 4.0 Ah pack charges in 90–120 minutes; if an aged pack no longer holds charge, replace it. Two batteries are included so work can continue.

Frequently asked questions

Need a recommendation or a quote? Send your strap width, load and quantity to AECSORIX, or WhatsApp +86 13606818153. We reply within 12 working hours.

Leave a Reply

Your email address will not be published. Required fields are marked *