PET vs PP Strapping: How to Choose the Right Band for 13–19mm Tools

PET and PP are the two dominant strapping materials. They look similar on a roll, but they behave very differently under tension — and picking the wrong one is the most common cause of weak joints and broken bands. This guide gives you the practical differences, so you can match the band to your load […]

13mm or 19mm Strapping? A Buyer’s Guide to Band Width

Strap width is the first specification buyers ask about, and the one most often chosen by guesswork. Too narrow and the joint fails; too wide and you pay for strength you never use. Here is a practical way to decide. Why width matters Joint strength scales with band cross-section. A wider belt spreads the load […]

Battery vs Pneumatic Strapping Tools: Which Fits Your Operation?

If you are moving from pneumatic strapping tools to battery-powered ones, the decision usually comes down to mobility, power consistency and total operating cost. This comparison is based on real warehouse and yard use, not spec-sheet marketing. Mobility Battery tools are fully portable — no air hose, no compressor, no fixed station. Operators can strap […]

How to Adjust Strapping Tension on a Battery Tool (600–3500N)

Tension is the single setting that decides whether a joint holds. Too little and the load shifts; too much and you crush the product or cut the band. AECSORIX tools make adjustment simple — here is how to do it correctly. Why tension matters With the right band and tension setting, a friction-weld joint reaches […]

How to Strap Steel Coils Safely: A Step-by-Step Guide

Steel coils are heavy, dense and unforgiving. A failed band during transport is a serious safety risk, so the strapping method matters as much as the tool. This guide covers a repeatable process used in steel yards. Why steel needs a different approach Coil edges are hard and can cut into a weak band. The […]